Instructions

4747
EN
. . .1.
2.
. . .
3 x +
approx. 10 s
Controlling blinds and dimmers in jog mode
Functional description of jog
mode
◆ If the UP and DOWN buttons are pressed briefly in jog mode, a jog command is transmitted. This
enables convenient adjustment of Venetian blind slats, as the motor only runs briefly.
◆ When used in combination with dimmers, jog mode causes the brightness to be increased or decreased
by 10%.
◆ If the UP and DOWN buttons are pressed for a longer duration (>1/2 second) then the normal UP and DOWN
signals are transmitted. Jog mode can be switched on and off separately for each group, where applicable.
Switching jog mode on and off
Select the desired group (1-6) with the correspond-
ing group button, where applicable.
Press and hold the STOP button for approx. 10
seconds.
Observe the button LED and status LED:
The LED for the selected group button flashes three times
and the status LED lights up:
green (jog mode is switched on)
orange (jog mode is switched off).
NOTE Actuators which do not support jog mode will ignore jog
commands.