Instructions

42
i
EN
11. Logging DuoFern transmitters on/off
You must assign every required DuoFern transmitter to the DuoFern
Connect actuator in order that the actuator can be controlled with a
DuoFern transmitter. You can assign max. 20 DuoFern transmitters
(e. g. RolloTron Pro Comfort DuoFern) to the actuator. Additional in-
formations about logging on can be obtained from the log-on matrix
on our website under www.rademacher.de.
1. Use the supplied SET
magnets (see page 47) to
touch either the “Connect
(log-on)” or “Disconnect
(log-off)” areas on the
actuator.
2. The status LED flashes
green, the drive starts
up briefly and a corre-
sponding signal is given.
NOTE:
Log-on/off mode remains
active for 60 seconds.
3. Switch the desired Duo
Fern transmitter to “Con-
nect” mode (log-on) or
“Disconnect” mode (log-
off) - (please refer to the
corresponding opera-
ting instructions).
SET Magnet
SET Magnet
SET Magnet (see page 47)
Connect (log-on)
Disconnect (log-off)