Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 3. Safety instructions
- 3.1 Intended use
- 3.2 Glossary - definition
- 4. Included in delivery
- 5. General view
- 5.1 Display icons
- 6. Product description
- 7. Technical specifications
- 8. Initial commissioning
- 8.1 Insert the enclosed batteries
- 8.2 Logging on to the HomePilot®
- 8.3 Logging on to the DuoFern Room Thermostat 2
- 8.4 Activating installation mode (POS)
- 8.5 Mounting on the radiator valve
- 8.6 Performing an installation run (InS)
- 9. Settings on the ready-to-use device
- 9.1 Setting the target temperature
- 9.2 Child protection function / operating lock
- 10. Introduction to opening the menus and setting the functions
- 10.1 Automatic function (Aut)
- 10.2 Boost function (boS)
- 10.3 DuoFern menu (duo) Logging on / logging off / clearing
- 10.4 Internal window open detection (dEt)
- 10.5 External window open detection
- 10.6 Internal or external controling (SEn)
- 10.7 Rotating the information on the display (dIS) (180°)
- 10.8 Reception interval (EIn)
- 10.9 Viewing the battery charge level (bAt)
- 10.10 Viewing the current software version (ld)
- 11. Deleting all settings and resetting to the factory settings
- 12. Error messages and troubleshooting
- 13. Cleaning / maintenance
- 14. Simplified EU declaration of conformity
- 15. Information about environmental protection
- 16. Warranty terms and conditions
13
EN
8.4 Activating installation mode (POS)
1. Activate installation mode by briey
pressing the button.
The drive then moves to the
installation position (POS). The display
ashes as soon as the installation
position is reached.
i
If a HomePilot
®
or DuoFern Room Thermostat 2
was already logged-on before the batteries
were inserted, the installation mode is activated
directly.