Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 3. Safety instructions
- 3.1 Intended use
- 3.2 Glossary - definition
- 4. Included in delivery
- 5. General view
- 5.1 Display icons
- 6. Product description
- 7. Technical specifications
- 8. Initial commissioning
- 8.1 Insert the enclosed batteries
- 8.2 Logging on to the HomePilot®
- 8.3 Logging on to the DuoFern Room Thermostat 2
- 8.4 Activating installation mode (POS)
- 8.5 Mounting on the radiator valve
- 8.6 Performing an installation run (InS)
- 9. Settings on the ready-to-use device
- 9.1 Setting the target temperature
- 9.2 Child protection function / operating lock
- 10. Introduction to opening the menus and setting the functions
- 10.1 Automatic function (Aut)
- 10.2 Boost function (boS)
- 10.3 DuoFern menu (duo) Logging on / logging off / clearing
- 10.4 Internal window open detection (dEt)
- 10.5 External window open detection
- 10.6 Internal or external controling (SEn)
- 10.7 Rotating the information on the display (dIS) (180°)
- 10.8 Reception interval (EIn)
- 10.9 Viewing the battery charge level (bAt)
- 10.10 Viewing the current software version (ld)
- 11. Deleting all settings and resetting to the factory settings
- 12. Error messages and troubleshooting
- 13. Cleaning / maintenance
- 14. Simplified EU declaration of conformity
- 15. Information about environmental protection
- 16. Warranty terms and conditions
18
EN
10. Introduction to opening the menus and
setting the functions
Dierent settings can be made and functions can be activated
(On) or deactivated (OFF) in the DuoFern Radiator Actuator 2
menu.
i
Navigation in the menu
Setting parameters, see next chapter
The settings are saved by pressing the menu button.
Return to the normal view
◆ Automatically after approx. 10 seconds without any input.
◆ By pressing and holding the menu button.