Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 3. Safety instructions
- 3.1 Intended use
- 3.2 Glossary - definition
- 4. Included in delivery
- 5. General view
- 5.1 Display icons
- 6. Product description
- 7. Technical specifications
- 8. Initial commissioning
- 8.1 Insert the enclosed batteries
- 8.2 Logging on to the HomePilot®
- 8.3 Logging on to the DuoFern Room Thermostat 2
- 8.4 Activating installation mode (POS)
- 8.5 Mounting on the radiator valve
- 8.6 Performing an installation run (InS)
- 9. Settings on the ready-to-use device
- 9.1 Setting the target temperature
- 9.2 Child protection function / operating lock
- 10. Introduction to opening the menus and setting the functions
- 10.1 Automatic function (Aut)
- 10.2 Boost function (boS)
- 10.3 DuoFern menu (duo) Logging on / logging off / clearing
- 10.4 Internal window open detection (dEt)
- 10.5 External window open detection
- 10.6 Internal or external controling (SEn)
- 10.7 Rotating the information on the display (dIS) (180°)
- 10.8 Reception interval (EIn)
- 10.9 Viewing the battery charge level (bAt)
- 10.10 Viewing the current software version (ld)
- 11. Deleting all settings and resetting to the factory settings
- 12. Error messages and troubleshooting
- 13. Cleaning / maintenance
- 14. Simplified EU declaration of conformity
- 15. Information about environmental protection
- 16. Warranty terms and conditions
20
EN
10.3 DuoFern menu (duo)
Logging on / logging o / clearing
You can log the HomePilot
®
or the DuoFern Room Thermostat 2
onto the DuoFern Radiator Actuator 2 in this menu (duo).
i
You can log on a maximum of one HomePilot
®
or
one DuoFern Room Thermostat 2. Observe the
information on battery consumption on page 11.
Please refer to the instruction manual for the
registered device.
1. Open the DuoFern
menu (duo) in the
Radiator Actuator 2.
A logged-on device
is displayed, if
available.
Logging on to / logging o the HomePilot
®
or DuoFern
Room Thermostat 2
2. Switch the HomePilot
®
or the DuoFern Room Thermostat 2
to registering or log-o mode as required.
3. Activate the desired function on the DuoFern Radiator
Actuator 2, see next page.