Owner's Manual

PAGE 8
Setting AutoCity Speed
Auto Shutdown
GPS Connected
GPS Error Message
GPS Lockouts
Mute Mode
settings
Select AutoCity Mode by pressing the
VOL-/CITY button.
AutoCity Mode operates as follows:
All radar alerts on X and K bands are
completely muted and only displayed
if the vehicle’s speed is lower than
the left speed setting (Low Speed
Mute). It does NOT mute Ka band
and Laser alerts.
Radar detector operates in City mode
with reduced sensitivity as set in City
Mode Filter if vehicle’s speed is be-
tween left speed setting (Low Speed
Mute) and right speed setting (City
Mode Speed).
Maximum detector sensitivity will be
achieved above right speed setting
(City Mode Speed). Radar detector
operated with maximum sensitivity
on all bands if vehicle’s speed is over
the right speed setting.
City Filter and City Mode Speed settings
are always default in Beginner Mode.
City Filter and City Mode Speed settings
can be changed in expert mode only.
To prevent drainage of the vehicle’s
battery, the radar detector automatically
shuts down after 30 minutes if the GPS
doesn’t detect vehicle movement. The
radar detector will need to be manually
turned on if it shuts down automatically.
If the radar detector is wired to a
switched power source, it will shut down
at the same time. The radar detector will
start up automatically once the switched
power source receives power.
Pressing the MUTE button during an alert
will temporarily mute the detected signal
and will automatically un-mute 20 sec-
onds after the signal has passed, or if a
new or different signal has been detected.
Pressing the MUTE button without an
alert will permanently mute the radar
detector on X and K bands until manually
unmuted or after a new startup cycle. Ka
band and laser alerts will NOT be muted
in this mode.
A GPS Connected message displays along
with a voice announcement when a GPS
signal is acquired after start-up.
You can disable the voice announcement
in the Menu (must be in Expert Mode).
A GPS Error message displays if the radar
does not receive a GPS signal for 30
seconds.
Mute audio alerts (voice/tone) for radar
within a 1,500 ft radius of the lockout
location.
Lockout display:
When entering a lockout location,
“LOCKOUT” is shown in the right
hand corner of the display
POI alert operates only when GPS is
connected
Press and hold the mute button for 2 sec-
onds to store or delete a lockout location.
Select “Del ALL lockout?” in the menu to
delete all lockout locations in memory.
•
•
•
1.
2.
3.
4.
1.
2.
1.
2.
1.
2.
1.
2.
3.
4.
5.
1.
•