Service manual

BLACKHEAT
®
INSTALLATION OPERATION AND SERVICE MANUAL
34 of 75
Step 7.8.1 Reflector, U-Clip and Reflector Support Installation
The pictorial drawings of the heater construction in
Section 6 are schematic only and provide a general
guideline of where hangers, reflector supports and
U-clips are to be installed.
To ensure proper expansion and contraction movement of
the reflectors, a combination of U-clips and reflector
supports are used. The positioning of reflector supports
and U-clips depend on the individual installation. Use
either pop rivets or sheet metal screws instead of U-clips
when installing end caps and joint pieces in areas where
impact and high wind may be a factor. The following rules
must be observed:
Description Part Number
Reflector Support Package 03050010
Wire Form 91908004
Reflector Support Strap 03050000
Screw #8 x 3/4 (3.9 x 19 mm) 94320812
U-Clip Package 91107720
Reflector End Cap 027508XX