User's Manual

16
Important Regulatory Compliance and User Information
The final product with the modules installed needs to be tested for FCC Part 15, IC (Industry
Canada) CE, EMI/RFI compliance. Radicom certification documentation will help streamline the
final product approval process. Contact Radicom for more information. To maintain compliance in
the finished product, carefully follow guidelines in this section. This device is intended only for
OEM integrators under the following condition:
The transmitter module may not be co-located with any other transmitter or antenna. As long as this
condition is met, further transmitter testing will not be required. However, the OEM integrator is still
responsible for testing their end product for any additional compliance requirements required with
the module installed (for example, digital device emissions, PC peripheral requirements, etc).
IMPORTANT NOTE: In the event that this condition cannot be met then the FCC authorization is
no longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including
the transmitter) and obtaining a separate FCC authorization.
Host (End Product) Labeling Requirements
To maintain compliance, the end product hosting the module must be properly labeled to identify
that this module is installed. The final end product must have a label located in a visible area with
the following information:
Contains Transmitter
Module
Model: XXXXXXX FCC ID:
K7T-RB1000
IC: 2377A-RB1000
XXXXXXX is for the model of the module used in the end equipment. The XXXXXXX will be
RB1000, RB1000HM, and BPM1000F. The label shall be securely affixed to a permanently attached
part of the device, in a location where it is visible or easily accessible to the user, and shall not be
readily detachable. The label shall be sufficiently durable to remain fully legible and intact on the
device in all normal conditions of use throughout the device’s expected lifetime. These requirements
may be met either by a separate label or nameplate permanently attached to the
device or by
permanently imprinting or impressing the label directly onto the device. The label text shall
be legible without the aid of magnification, but is not required to be larger than 8-point font size.