User's Manual

17
End User Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF Exposure
compliance. The end user should NOT be provided any instructions on how to remove or install the
device. The user’s manual for end users must include the following information in a prominent
location.
FCC RF Radiation Exposure Statement
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, this device must
not be co-located or operating in conjunction with any antenna or transmitter. This device contains a low
power transmitter. When this device is operational, use only with the supplied, or recommended antenna.
Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC
regulations. Changes or modifications not expressly approved by the manufacturer or party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1)
This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and radiates radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. There is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for assistance
.
IC (Industry Canada) Statement:
“This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device”
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
license. L’exploitation est autorisee aux deux conditions suivantes: (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit acceptor tout brouillage radioelectrique subi, meme si le
brouillage est susceptible d’en compromettre le fonctionnement.
The final end product must be labeled in a visible area with the following: “Contains FCC ID: K7T-
RB1000, IC ID: 2377A-RB1000”