User's Manual

22
O Return to Data Mode - The ATO command is used to exit the On Line Command
Mode and return to the On Line Data Mode. When this command is entered the
module will respond with the appropriate CONNECT result code. This command
is invalid if frequency hopping is enabled. See Changing from Data Mode To
Command Mode for more information on the ATO command.
Qn Quiet results codes control – Each time an “ AT” command is issued, the module
will respond with a response or result code. The ATQn command determines if
the module will issue result codes to the DTE or host equipment.
Q0 Issue result codes to the DTE (default).
Q1 Do not issue result codes to the DTE.
\Qn Flow control- Controls the data flow between the modules and host.
\Q0 Disables flow control.
\Q1 Bi-directional XON/XOFF flow control
\Q2 CTS hardware flow control (default)
\Q3 Enables RTS/CTS Hardware flow control
\Q4 Enables XON/XOFF Send only flow control.
\Tn Inactivity Timeout – Determines the period of inactivity before the module will
drop the link and return to the command mode. The value of “ n” is in one minute
increments. The default is “ 0”.
\S Display current configuration. The AT\S command will display the modules
Active Profile as well as the modules Stored Profiles.
Sr Read or write to S-register “r”. The ATSr command allows the reading and
writing of new values any valid S register.
ATSr= n Sets S-register “ r” to the value “ n”
ATSr? Reports the value of S-register “ r”