User's Manual

9
FCC Part 15 User Information – The manual or installation guide for the finished
product must contain the following information:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Consult the dealer or an experienced radio/TV technician for help.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
RF EXPOSURE WARNING - The FCC has developed guidelines to reduce any
possible hazard due to exposure of the human body to electromagnetic radiation The
antenna installation must provide a separation distance of 20cm (8") between the antenna
and all persons.”
FCC Part 15 Labeling Information - When the module is installed in a finished
product with no antenna modifications, the finished product must be labeled with the
following:
The above labeling information may be added to the finished product’s label or can be on
a separate label. The finished product’s label must have it’s own FCC ID (XXX-XXXX)
and the following information.
Contains FCC ID: K7T-WHM900
FCC ID: XXX-XXXXX
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Contains FCC ID: K7T-WHM900
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment!