Specifications

Chapter 1 Logic Control—Basics 15
Connecting the Unit(s)
Connect your Logic Control and/or Logic Control XT units as shown in the diagram
below.
As mentioned above, each Logic Control or Logic Control XT unit must have a discrete
MIDI in and MIDI out connection. Do not “daisy-chain” other MIDI devices via MIDI THRU
to the MIDI in or out ports used by the Logic Control units as this may result in data
errors.
About the Power Supply Unit (PSU)
The PSU which came with your Logic Control unit is rated at 7.5V, 4.0 Amps, with a
positive tip. Do not use any other power supply with the Logic Control units as this
may result in permanent damage. Any attempt to use another power supply with
either unit will automatically void your warranty.
Should you have a problem with the power supply unit, immediately disconnect it
from the Logic Control and wall socket to avoid damage or electrical shock. There are
no user-serviceable parts in the power supply unit (or the Logic Control units). If you
have a problem with your Logic Control or power supply unit, please contact the local
Emagic distributor in your region or territory.
Optional Footswitches and pedals
You may use optional foot switches to remotely control the start/stop and other
functions of the Logic Control. This may be useful for guitarists or other two-handed
playing. The foot switch sockets can use momentary foot pedals with either a positive
or negative polarity. By default:
• USER SWITCH A
is assigned to Start/Stop .
• USER SWITCH B
is assigned to Record (note that a track must be selected and armed
for recording to take place),
Computer
MIDI Interface
Optional Footswitches