Specifications

Chapter 1 Logic Control—Basics 21
Simply press the LEFT/RIGHT CURSOR keys to step up/down to the next “page” of
parameters.
The current/total number of pages (e. g. “Page 1/3”) is displayed in the top right-hand
corner of the LCD whenever multiple “pages” are available—i. e. when parameter
names are shown in the lower row.
To get to the first or last page, hold down OPTION while pressing the LEFT/RIGHT
CURSOR key.
Switching by page is just the default. To switch by a single parameter, hold down C/
ALT while pressing the appropriate cursor key.
Viewing by Name or Value
As a personal preference, or for practical reasons, you may wish to view parameters by
their name, or by value. To toggle between the two Display formats—Name or Value—
repeatedly press the NAME/VALUE button in the Display section of the Logic Control—
just below the SMPTE/BEATS LEDs.
It should be noted that the NAME/VALUE button has a significant impact on the Multi
Channel and Channel Strip views of the various Assignment modes. The use of the
NAME/VALUE button in these view modes is covered throughout The Assignment Zone
section, from page 31 onwards.
The Displays
Liquid Crystal Display (LCD)
The LCD is a 2 row × 55 character backlit display.
Below the display, you will see eight (8) “notched” areas which act as visual cues,
making the separation of channels/parameters easier. These are numbered 1—8.
Short names
Each channel/parameter can be indicated by a name or value, up to 6 characters long,
dependent on the currently selected Display mode. In general, the upper row of each
channel/parameter will display the track name, and the lower row will display the
parameter name and/or value.