Specifications

32 Chapter 2 Logic Control—Details
When these buttons are pressed, the Mode Display, plus the LED associated with each
button, will update to reflect the currently selected assignment “mode”. The LCD will
also update to display the parameters relevant to the selected Assignment. These
parameters, are, of course assigned to the corresponding V-POTs.
All ASSIGNMENT buttons work as toggle switches, which means that if you click them
repeatedly, they will switch between the Multi Channel and Channel Strip View modes.
• Multi Channel View—you see the same parameter for multiple channels. In Multi
Channel View, the Mode Display does not show a period—e. g.
P1
• Channel Strip View—you see multiple parameters for a single channel. In Channel
Strip View, the Mode Display shows a period to the right—e. g.
P1.
Switching between Multi Channel and Channel Strip views is achieved by pressing the
selected ASSIGNMENT button multiple times.
When pressing an ASSIGNMENT button which is not currently selected, the Assignment
mode changes, and the view switches to Multi Channel View. Exception: switching
between Instrument Edit View and Plug-in Edit View retains Channel Strip View.
The NAME/VALUE button also has an effect on what is shown on the LCD when in the
Multi Channel and Channel Strip views. More information can be found in Display Zone
section, from page 49 onwards.
Changing Parameters and Values
Individual parameters can be adjusted via the associated V-POT (or fader, if the FLIP
button is active), located directly below the parameter entry in the LCD.
To do so, simply grab and turn the desired V-POT. Once the required parameter value is
visible in the LCD, simply release the knob.
Press the V-SELECT button to set the default value (for parameters which have more
than 2 values), or to toggle between two values for parameters with only two
possibilities (e. g on/off).
Some parameters require that a “confirmation” be made, such as Plug-ins, Audio
Instruments, Sends, Inputs and Outputs etc. For these types of parameters, press the V-
SELECT
switch (press down on the top of the V-POT) to activate/select the desired value.
In the case of a plug-in or Audio Instrument, this will automatically launch the Plug-In
window in Logic. For a Send, the confirmed channel Send destination will be activated in
Logic’s Mixer(s).
When a value has been pre-selected, but not confirmed/instantiated (such as Send
Destination, Plug-In insertion etc.) the value will flash until the V-SELECT switch is
pressed.
An exponential increase in value changes will occur as a V-POT is rotated faster.