Specifications

Chapter 2 Logic Control—Details 43
Channel Strip View
This mode shows the plug-ins associated with all Insert “slots” for the selected channel.
• The Mode Display will show
PL.
• The upper LCD row shows Ins1Pl through Ins8Pl
• The lower LCD row shows the plug-in which is currently selected for this insert slot.
Muted plug-ins are indicated by an asterisk *, which precedes the plug-in name.
• Turning the V-POTs pre-selects a new plug-in. Until activated, the plug-in name
flashes.
• Turning another V-POT will cancel any previous pre-selection and will start pre-
selection on the newly selected track.
• Pressing a V-SELECT:
• activates the pre-selected plug-in (assuming that you’ve made your pre-selection
by turning the V-POT)
• opens a plug-in editor window if none are opened (if a plug in window is opened,
and link mode is enabled, the selection of another plug-in will replace the existing
plug-in)
• switches to Plug-in Edit View
To remove a plug-in, pre-select the value of “--” (by turning the V-POT all the way
counterclockwise), and press the V-SELECT linked to the appropriate Insert slot. Logic
Control will not switch to Plug-In Edit view, and no Plug-In window will be launched. If
one was previously opened, it will be closed (if the “chain” icon is inactive).
• Pressing a V-SELECT while the OPTION button is held down will mute/unmute the
plug-in
Plug-in Edit View
• The Mode Display will show
P1.
to
P8.
, depending on the number of the selected
Plug-In Insert “slot”.
• Dependent on the NAME/VALUE button, the LCD display will change in the following
ways between the two modes:
• Name The upper LCD row shows the track’s name, insert number, plug-in name,
current parameter page and total number of parameter pages.
The lower LCD row shows the name of the parameter which is edited via the V-POT
below.
• Value The upper LCD row shows the name of the parameter which is edited via
the V-POT below.
The lower LCD row shows the current value of the parameter edited with the V-POT. If
there is sufficient onscreen space, the unit type will be added—e. g. Hz.
• Turning the V-POTs changes the parameter