Specifications

7
Preface
What Is Covered
This manual covers Logic’s dedicated control surface
support. Please read it thoroughly to make the most of
your new controller(s).
Logic comes with dedicated support for certain control surface models. There are
several plug-ins which are are a part of Logic. Some plug-ins support multiple similar
control surface models.
You can use any combination of control surfaces with Logic. However you get the most
out of them when using them in a Control Surface Group if they are all supported by
the same plug-in.
Here you find an alphabetic list of the supported control surfaces, how they differ from
similar devices and a cross reference to the relevant sections.
CM Automation Motormix
Only available in Logic Pro, not in Logic Express.
See section “CM Labs Motormix” on page 133.
CM Labs Motormix
Only available in Logic Pro, not in Logic Express.
See section “CM Labs Motormix” on page 133.
Emagic Logic Control
If you have installed Mackie’s firmware version 1.0.2 or higher, make sure that the Logic
Control runs in Logic Control mode. See sections “Logic Control—Basics” on page 13
and “Logic Control—Details” on page 26.
Also see the Appendix for more details.