Specifications

8 Preface What Is Covered
Emagic Logic Control XT
This is the extension unit for the Logic Control. It has only the channel strip section;
therefore it is not useful without a Logic Control.
If you have installed Mackie’s firmware version 1.0.2 or higher, make sure that the Logic
Control XT runs in Logic Control mode.
See sections “Logic Control—Basics” on page 13 and “Logic Control—Details” on
page 26.
Also see the Appendix for more details.
Mackie Baby HUI
Only available in Logic Pro, not in Logic Express.
The Baby HUI is a stripped-down version of the HUI. For easier navigation, we have
documented it in a separate section.
See section “Mackie Baby HUI” on page 98.
Mackie C4
The Logic Control plug-in has been extended for dedicated support for the Mackie C4.
Please see section “Mackie C4” on page 73.
Mackie Control
The original Mackie Control is similar to the Logic Control in hardware, however the silk
screening is different. You should request a Logic Control Lexan Overlay from Mackie to
get the correct silk screening. See
http://www.mackie.com/products/mackiecontrol/mackiecontrol_overlay.html
Firmware version 1.0.2 or higher is required, and it must be switched to Logic Control
mode.
See sections “Logic Control—Basics” on page 13 and “Logic Control—Details” on
page 26.
Mackie Control Extender
Firmware version 1.0.2 or higher is required, and it must be switched to Logic Control
mode. See the documentation from Mackie on how to switch to Logic Control mode.
See sections “Logic Control—Basics” on page 13 and “Logic Control—Details” on
page 26.