Specifications

Chapter 4 Tascam FW-1884 87
Channel strips
EQ Section
The EQ controls apply to a certain EQ band of the selected track. A Channel EQ must be
inserted in the track (or the song must use the old, pre 6.0 EQs).
Control Assignment
REC LEDs These LEDs are on when the corresponding track is recording and flash when the track
is Record Ready
SEL selects the track
SHIFT when encoders control a Send Level, toggles Send Mute
READ sets the track’s automation mode to Read
WRITE sets the track’s automation mode to Write
TCH sets the track’s automation mode to Touch
LATCH sets the track’s automation mode to Latch
SOLO toggles the Solo status of the track
MUTE toggles the Mute status of the track
Encoder controls parameter chosen with the ENCODERS section
SET when ENCODERS section has chosen Send editing, sets the Send’s destination
Fader controls volume of the track
Mode Assignment
REC while held down, the SEL buttons in the channel strips toggle Record Ready status
GAIN edits Gain of currently selected EQ band
SET selects Track input
FREQ edits Frequency of currently selected EQ band
SET selects Track output
Q edits Q factor of currently selected EQ band
SET selects Track mode
HIGH selects parametric EQ band 4 (for Channel EQ)
SHIFT selects High Cut (for Channel EQ)
HI-MID selects parametric EQ band 3 (for Channel EQ)
SHIFT selects High Shelf (for Channel EQ)
LOW-MID selects parametric EQ band 2 (for Channel EQ), or EQ band 4 (for pre-6.0 EQs)
SHIFT selects Low Shelf (for Channel EQ), or EQ band 2 (for pre-6.0 EQs)
LOW selects parametric EQ band 1 (for Channel EQ), or EQ band 3 (for pre-6.0 EQs)
SHIFT selects Low Cut (for Channel EQ), or EQ band 1 (for pre-6.0 EQs)