User manual

To choose an automation mode on the MC Pro
1 Press the Wave and Select keys simultaneously.
2 Select the automation mode you want from the pop-up menu displayed on the
touchscreen. You can choose between:
• Isolate: Automation mode is off.
• Read: Activates Read mode in Logic Express.
• Write: Activates Write mode in Logic Express.
• Read/Write: Activates Touch mode in Logic Express.
You can also use the Select key to switch between automation modes in Logic Express:
• When you set the automation mode to Off or Read, the Select key switches between
these two modes.
• When you set the automation mode to Read or Touch, the Select key switches between
these modes.
To choose an automation mode on a CM408T channel strip
1 Press the Wave and Y keys simultaneously.
The available automation modes are displayed in a pop-up menu on the CM408T display.
2 Use the fader of the channel strip to scroll through the following options:
• Isolate: Automation mode is Off.
• Read: Activates Read mode in Logic Express.
• Write: Activates Write mode in Logic Express.
• Read/Write: Activates Touch mode in Logic Express.
3 Use the Y key to confirm your selection, or the N key to cancel the operation.
Note: If a write automation mode (Touch, Latch, Write) is active (and an automation
parameter is enabled in the Logic Express > Preferences > Automation > Touch/Latch/Write
Erase settings), the red “W” LED is lit. The green LED is lit when a read automation mode
is active. Both LEDs are lit when Touch or Latch mode is active.
To choose an automation mode on MC Artist devices
1 Press and hold down the Shift key.
2 Press the AUTO key repeatedly until your chosen automation mode appears on the display
screen. You can choose between:
• Blank: Automation mode is Off.
• Read (r): Activates Read mode in Logic Express.
• Write (w): Activates Write mode in Logic Express.
• Read/Write (rw): Activates Touch mode in Logic Express.
126 Chapter 5 Euphonix MC Pro, System 5-MC, MC Control, MC Mix, and MC Transport