User manual

AssignmentModifierControl
Switches Channel view modes between:
• Instrument Edit mode (LED on). (Instrument
window opens.)
• Pan Edit mode (LED off ).
Instrument plug-in window closes when
Instrument Edit mode is exited.
SHIFT
In Pan Edit mode:
• Controls channel strip Pan/Balance.
In EQ/Send mode:
• 1/3/5/7: Control the Gain parameter of EQ
bands 1–4.
• 2/4/6/8: Control the Frequency parameter of
EQ bands 1–4.
• 9–12: Control Send 1–4 levels.
In Plug-in Edit mode:
• 1–10: Edits plug-in parameter.
• 11: Bypasses the plug-in.
• 12: Shifts plug-in parameter page. (A page is a
collection of parameters.)
In Instrument mode:
• 1–10: Edits Instrument parameter.
• 11: Bypasses the instrument plug-in.
• 12: Shifts Instrument parameter page.
PAN 1 to 12
In EQ/Send mode:
• 2/4/6/8: Control the Q-Factor of EQ bands 1–4.
• 9–12: Determine Send 1–4 destinations.
SHIFT
Selects track/channel.CH SELECT 1 to 12
In Automation mode: Switches Automation mode
between:
• Off (LED off )
• Read (green)
• Latch (orange)
• Write (red)
In Record Ready mode: Activates/deactivates
Record Enable. In Solo mode: Enables/disables
Solo. In Mute mode: Enables/disables Mute.
STATUS 1 to 12
Controls volume.Fader 1 to 12
Roland SI-24: STATUS MODE Section
The following table outlines the status mode controls and their assignments:
Note: A modifier button (such as SHIFT) shown below a button description indicates that
the button has an alternate function or use while the modifier is held down.
215Chapter 17 Roland SI-24