User Manual

131
SPECTRALIS 2
The parts can be selected by pushing the encoder buttons under the display.
The menu exits automaticly after the selection. [current] leaves the menu without
changing the selection. Part 12 is assigned to triggergroup 1, part 13 to
triggergroup 2 and part 14 to triggergroup 3. Each subpart has its own
sequencerline target and sequencer part in the motif sequencer.
This submenu can also be used to change the assignment of triggergroups.
Instead of pressing the encoder buttons for a selection one can press the page
up button and reaches the parameters of the triggergroup selection directly.
4.6 VCA Section
The VCA LEVEL knob controls the bus volume of both analog filters directly.
In most cases - especially when using the filters in a parallel configuration or
only one filter for the sound, this control can be used as a premixer volume
knob.
Pushing the VCA LEVEL encoder opens a menu for the BUS Level of all
filtersections:
Filter to Bus
MM:37 LP:237 FB:255
„MM“ - (Multimode filter bus Level) controls the Bus level of the multi-
mode filter.
„LP“ - (24dB lowpass filter bus level) controls the bus level of the 24dB
lowpass filter.
„FB“ - (Filterbank bus level) controls the bus level of the fixed filterbank.
The FB Balance (Filterbank Balance) encoder controls the output volume of
the two anolog filters and the fixed filterbank in opposite directions. Turning
the encoder to the right decreases the filterbank volume and increases the ana-
log filter volumes.
Pushing the FB BALANCE encoder opens a menu for pan control of both
analog filters.
Filter Pan
MM:<C> LP:<C>
The stereo position of both filters can be controlled independently. The stereo
position of both filters become only audible at the sum output or the hybrid
synth direct output.
The EG BALANCE encoder controls the envelope bypass of both filters at
once. Whenever one wants to use the analog filters without triggering or playing
Hybrid Synthesizer reference: VCA section