User Manual

38
SPECTRALIS 2
"Keyboard-Scaling"-settings can be adjusted as follows:
Push the [Shift]-button and turn the (Reso-MM)-knob. The value of the
keyboard-scaling will be displayed while the changes are taking place. When
you are pushing the (Cutoff MM)-encoder button, the KeyScaling Parameters
will be visible continuously in the display.
1/3 Filter Parameters
Scale:12 Pitch:A3
The parameter ”Pitch” determines the key, which - when used - will have no
effect on the frequency during keyboard scaling. With positive values set for
the keyboard scaling, the keys above the note selected here will raise the
frequency of the filter up und keys below this value will lower the frequency
downward.
3.2.12 The DSP-synth LFO-section
The samplebased DSP soundengine provides 2 LFO's for parameter modulations
.The three encoders [LFO-WAVE], [MOD-DEPTH] and [MOD-RATE] in
the LFO section allows for editing of these parameters direct for both LFOs.
Pushing these encoder buttons opens up the menu for independent parameter
tweaking of both LFOs.
[LFO WAVE] opens the menu for the LFO waveform selection..
LFO Wave Menu (Dsyn1)
Lfo1: 0 Lfo2: 0
Encoders 1 and 2 are selecting the LFO waveform for LFO 1 and LFO 2 from
a wavetable.
[MOD DEPTH] - opens the menu for independent mod-depth control for LFO1
and LFO2..
LFO Depth Menu (Dsyn1)
´`Lfo1: 0 ´`Lfo2: 0
The little arrows to the left of the parametername are indicating, that you can
open further menus for LFO depth control.
1/2 LFO 1 Depth Modifier Menu (Dsyn1)
LEDl: 0 LEAt: 0 LErl: 0 LEdp: 0
Two additional edit pages can be found for both LFO's. The first one has been
selected. The following parameters are now available:
[LEDl] - controls the delay until the LFO depth envelope gets triggered after a
key has been pressed down on your keyboard.
Editing DSP-synth sounds - LFO section