User Manual
39
SPECTRALIS 2
[LEAt] - controls the attack time of the depth envelope.
[LErl] - Controls the release time of the LFO depth envelope.
[LEdp] - Controls how much the depth envelope affects the modulation depth.
By hitting [Page-Up] you reach the second menupage:
2/2 LFO 1 Depth Modifier Menu (Dsyn1)
LMWD: 0
[LMWD] - controls, how much the modulationwheel controls the LFO-depth.
3.2.13 Assigning LFO and MIDI modulation to the cutoff frequency
The LFO and MIDI controls can be assigned to the cutoff frequency for filter
modulation. The filter-cutoff menu of the DSP engine comes with three menu-pages.
You can reach these menu pages by hitting one of the [cutoff]-encoder buttons.
Entering the menu followed by hitting [Page-Up] opens the assignment dialog:
2/3:Filter Cutoff Modulators (Dsyn1)
Src1:None Dph1:0 Src2:None Dph2:0
On the second menupage, you can choose between different modulation sources for
the Cutoff-Frequency - the two LFO’s, aftertouch, breath-controller and the
pitchbend wheel. Are you may missing velocity and the modulation-wheel in this
dialog? Don’t worry, these very essential modulators can be adjusted independently
from the modulation routing options on page 3/3:
3/3:Filter Cutoff Modulators (Dsyn1)
CoMw: 0 CoVel: 0
"CoMw“ controls the depth of the modulation-wheel cutoff tweaking and "CoVel“
controls the velocity control over the filter frequency.
3.2.14 Assigning LFO and MIDI modulation to resonance, volume, panpot
position and DSP oscillator pitch
The same two menu pages described in the chapter above can be found in the VCA-
Level, OSC-Detune, "FB-Balance" and VCA-Level menu for the corresponding
parameters. The following encoder-buttons can be pushed down to enter the menus:
[OSC DETUNE] - modulation assignment pages for pitch modulation.
[RESO MM] or [RESO MM] - modulation assignment for the filter resonance.
[VCA LEVEL] - modulation assignment for the VCA Level (Volume).
[FB BALANCE] - modulation assignment for the panpot position.
Editing DSP-synth sounds - filter modulation