User Manual

SPECTRALIS 2

In this menu you can select and edit the modulation sources and pitch-

modulation depths.

24dB Lowpass filter frequency and resonance modulation

1.) push the [Cutoff LP] encoder button in the filter section

2.) Use the [Page-Up] button to select menupage 4/8 to choose the following

menupage:

4/9:24dB Lowpass: Cutoff-Modulators

Src1:None Dph:0 Src2:None Dph2:0

You now can adjust the desired modulation sources and modulation values.

Pushing the [Page-Up] button again will take you to the filterresonance-control page:

5/9:24dB Lowpass: Resonance-Modulators

Src1:None Dph:0 Src2:None Dph2:0

Multimode filter frequency-and resonance-modulation

1.) Push the [Cutoff MM] encoder button in the filter section

2.} Using the [Page-Up] button select menupage 4/7 to prompt the following

menupage:

4/8:Multimode: Cutoff Modulators

Src1:None Dph:0 Src2:None Dph2:0

The resonance modulators page for the MM-filter follows at page 5/8.

LFO sections

By now you should be somewhat familiar with some key details of the LFOs.

However we have not yet discussed the 6 additional LFOs, which can be found

in the edit sections of the individual sound creation banks. For many of you 4

LFO might be enough. If you want to liven up sounds in a more detailed and

subtle fashion, you can never have enough LFOs. The section LFO's don't

quite have the range of parameters as the master-LFO's. They still should be

sufficient to basic tasks - as they do have the same wavetable waveforms as the

master-LFO's. The section LFO's always are always set to freerunning operation.

Filter section LFO's

When using the 24dB Lowpass and the Multimode filter the parameters of the

section-LFO's can be found directly on the first 2 edit-pages. You'll get there

by pushing the [Cutoff] encoder button:

24dB Lowpass section-LFO menupage

1/9:24dB Lowpass: Cutoff Modulation LFO

FmWve:0 FmRte:0 FmDpt:0

Hybrid engine - The LFO section