User Manual

56
SPECTRALIS 2
Multimode filter section LFO menupage:
1/8:Multimode: Cutoff Modulation LFO
FmWve:0 FmRte:0 FmDpt:0
[FMWve] - filterfrequency modulation LFO waveform
The first encoder selects the desired waveform. You can find an overview
of the waveforms in the description of the master-LFO waveforms.
[FmRte] - Rate of the filterfrequency modulation
At 0 value the LFO oscillates at it's slowest rate and at 255 value at it's
fastest.
[FmDpt] - Frequency modulation depth
This parameter controls the Modulation depth of the LFO.
Pressing [Page-Up] one time in both filters opens the second section LFO edit
page:
2/9:24dB Lowpass: LFO Depth Envelope
FmEDl:0 FmEDa:0 FmEDr:0 FmEDp:0
The filter section LFO's have a delay and an envelope parameter to control the
modulation depth of the LFO.
[FmEDl] - Cutoff frequency modulation delay
At value 0 the modulation takes effect immediately when hitting a key,
at higher values the modulation starts with a delay.
FmEDa: - Cutoff Frequency Modulation Depth Envelope Attack Time
FmEDr: - Cutoff Frequency Modulation Depth Envelope Release Time
FmEDp: - Cutoff Frequency Modulation Envelope Depth
Oscillator Section LFO's
In the oscillator section there are also additional sections-LFO's. Each oscillator
has its own LFO for frequency modulation. You will reach these LFO's in the
oscillator pitch-menu, which can be selected using the [OSC-Detune] encoder
button. On the first menupage you will see the following parameters:
1/4:VCO Fine Tune
^Osc1:-11 ^Osc2:+11 ^Osc3:0 ^Osc4:0
In this menu you can set the finepitch of the oscillators. Looking at the small
indicated arrows, you can see that it is possible to jump to an additional menu-
section from here.
The sub-menu under this edit page has 12 sections - 3 for each oscillator. Each
one of these 3 pages is reserved for the control of the corresponding section
Hybrid engine - The LFO section