User Manual

64
SPECTRALIS 2
LOW
Lowest Note Priority without retriggering of envelopes during legato
play.
LO-TR
Lowest Note Priority with retriggering of envelopes during legato play.
HIGH
Highest note priority without retriggering of envelopes during legato
play.
HI-TR
Highest Note Priority with retriggering of envelopes during legato play.
You will find the menu for setting the assorted note priority choices and retrigger
options in the expanded part-select menu for the analog synth.
Use the Part->[Select]-button and then push and hold the numeric button [12]
button until you reach the expanded menu:
1/4:S01:Bass2Ass PA01:BasicBass PA:12
[Part12] [Part13] [Part14] [current]
Push the [Page-Up]-button three times. This will open the menu for setting the
notepriority and triggerswitches:
4/4:Trigger-Group Note-Priority
TG1:HIGH TG2:LOW TG3:HI-TR
Using the Encoders 1-3 under the display the trigger and note priority settings
for triggergroups 1 - 3 can be selected. For most analog synth sounds of the
soundlibrary triggergroup 1 is in use. If you have selected a solosound on the
analog synth part and you want to explore these settings, triggergroup 1 is the
one in use usually. You should instantly hear the result if you change the settings
there. Please keep in mind that you can save the settings for note-priority and
triggersetting for each separate sound. When you are choosing a different sound,
the original settings of this sound will be restored.
You have an additional direct access to the Triggergroup definition menu by
simply pressing the [SET ROUTING] button in the filter section!
What the hell are
trigger-groups?
The sound engine of
the analog synth can
be divided into
subparts. For example
one can create 3
different voices by
using one VCO and
the LP-filter for voice
1, 2 VCOs and the
MM-Filter for voice 2
and 1 VCO, noise and
the filterbank for the
third voice.
By defining trigger-
groups, you instruct
the system which part
12, 13 and 14 triggers
which envelopes. In
the example above you
would create three
triggergroups. Trigger-
group 1 would trigger
VCO 1- and the LP-
Filter-envelopes,
trigger-group 2 VCO 2
and 3- and the MM-
filter- envelopes and
trigger-group 3 would
trigger the VCO 4-,
noise- and filterbank-
envelopes. Trigger-
groups can use
independent sequen-
cerlines and pattern
sequencer motifs.You'll
find more on this later
in this manual.
Hybrid engine - Note priority &multitrigger settings