User Manual

78
SPECTRALIS 2
triggering of the Master-LFO envelopes is assigned to the trigger groups of
oscillators 1-4. If you are assigning oscillator 2 to trigger group 3, the Master-
LFO2 will also be controlled by trigger group 3. Keep in mind, that even though
trigger-groups have been defined no sound has yet been created. Once you
have assigned oscillator 1 and the multimode filter to a trigger group, you will
have to route the oscillator into the multimode filter and then assign the multi-
mode filter to an output to generate a sound. More on this subject in chapter
3.3.4.
Tip1: All filters – the low-pass filter, the multimode filter and the filter-
bank - allow for routing of the output signal not only to an output but also
additionally into the effect section. This means you can even add some
effect to the three parts separately from each other (select menupage 7/9
of the 24dB Lowpass filter menu or page 7/8 of the multimode filter menu)
Tip 2: Fans of phase modulation, frequency modulation or oscillator
synchronization will be happy to hear, that the independent routing can
be used to control the modulating oscillators independently. Just assign
one of the two phase-modulators VCO3 and 4 to their own trigger group
and use it to modulate VCOs 1 and 2. It will become apparent why it
makes sense to be able to determine the routing completely independent
of the trigger groups.
Tip3: You have direct access to the trioggergroup definition menu by
pushing the [SET ROUTING] button in the filters section.
The definition of triggergroups