User Manual

SPECTRALIS 2

these smooth transitions. Just hit the steps you want to get smooth results for

with the buttons 1-16 and change the transition time with the LGld- (Lineglide)

parameter.

Step-mute

The mute function not only disables the step envelope trigger points but also the

offset values will be suppressed for muted steps as well:

5/8:Fnc Mute ->FBV 390 Hz Stp:01-16

Seq:L03

Numeric buttons 1-16 can be used for the mute function, if this menu page is active.

Line-length

We already have described the menu for defining the line length. You may be

wondering, why we are adding a second page for that. We did that to improve the

workflow a little bit. Just memorize, that you can select the line length definition by

holding down the [Function]-button and pressing the numeric button 5. This menu

has some advantages compared to the other one, because it does not have to handle

multiple parameters. That allows to show some other important info like the current

sequence segment information (here 01-16) and the line selection.

6/8:Fnc Mute ->FBV 390 Hz Stp:01-16

Seq:L03 Len:17

3.8.2 Triggerpoint muting and overwriting

Menupage 7 is another dialog we added for improving the workflow a little bit. This

menu allows you to mute/unmute triggerpoints and to enter new triggerpoints

in one single edit page. Numeric buttons 1-16 are assigned to the triggerpoint

mute/unmute function. [Shift] + Encoder-button [1]-[16] copies the display

settings to the corresponding step. Aside from the combined button and encoder

functionality, the menupage is largely identical to the first edit page:

7/8:Fnc TrigSet->FBV 390 Hz Stp:01-16

Seq:L03 ´`Typ:Attac´`Len:4th ´`Depth:63

3.8.3 Single step editor

Encoder buttons [1]-[16] activate a special single step editor mode in the

sequencer menu. This menu allows for selecting steps and editing them. You

can use this dialog to check the step values of a sequence line as well.

Edit Step 1 ->FBV 390 Hz Stp:01-16

Off:0 Typ:Decay Len:4th Depth:0

The upper row of this menu displays the current selected stepnumber and the

line assignment. By hitting encoder buttons [1]-[16] other steps can be selected

directly. [Page-Up] and [Down] allows to jump for and backwards in your

Step sequencer advanced II - Parameter control lines