User Manual

82
SPECTRALIS 2
sequence to edit one step after the other. Press and hold [Shift] and [Page-Up]
and [Page-Down] to reach other sequencerlines without leaving the singlestep
edit mode.
If you want to copy the settings of the current step to other steps in the sequencer
line, just press and hold [Shift] and hit the encoderbuttons, you want to copy
the settings to.
Hitting the numeric buttons activates the triggerpoints for the corresponding
step positions.
You can leave this special single step editor by pressing [Exit].
3.8.4 Single parameter editor
All step parameters have additionally a special edit menu that allows a very
fast updating of sequence parameters. A "SetAll" function allows to initialise
one parameter for a complete sequence line with a selectable value.
This special single parameter editor can be reached from the first and the seventh
menupage of the sequence edit menu. Select the sequence menu by hitting
[Function] and select the 1st or the 7th menupage. You should see the following
menu:
1/8:Fnc TrigMod->FBV 390Hz Stp:01-16
Seq:L03 ´`Typ:Decay´`Len:4th ´`Depth:63
Encoderbuttons [2]-[4] under the display are entering the single parameter editor.
1/4: Offset->FBV 390 Hz Stp:01-16
Seq:L03 Off:0 [SETALL]
With [Page-Up] and [Page-Down] all other single parameter edit pages become
available.
The editor works in the way that you are setting a value with the display encoder.
Afterwards you can hit all numeric buttons corresponding to the steps, you
want to update with the new value. If you want to set the value for the entire
sequence line simply press [SetAll] with the display encoderbutton.
Menupage 1 is assigned to the step offset values, page 2 selects the envelope
type, page 3 the length of the step envelope and page 4 the depth of the step
envelope modulation.
Step sequencer advanced II - Parameter control lines