User Manual

SPECTRALIS 2

Setting the transpose settings for the current songstep

Press and hold the [Transpose]-button and select the desired transpose

setting with the Spectralis "Mini-Keyboard". Pressing the CFlat will

play the original pitch.

Setting the Solo-Settings of the current songstep

Press and hold the [Solo]-button and select the parts with the num-buttons

to specify the solo-seting for the current songstep.

Set repeats for the current songstep

With the encoder underneath the display you can set the number of times,

a songstep will be played. The length of a single songstep is dependent

on the pattern length you specified in the edit pattern section. Changing

the pattern length is described below. You may should specify the lengths

of all patterns before starting the song-chain editing. Otherwise you always

have to jump between songchain editor and pattern editor. It's much faster

and easier to do the pattern editing as the first job. By default, all patterns

are set to a length of 4 bars.

Truncate the beginning of a songstep pattern

Sometimes, you want a pattern play only a truncated version of itself.

The beginning truncate function allows to cut the beginning of a pattern

in steps of quarter notes.

Truncate the end of songstep pattern

Sometimes you want to truncate the end of an pattern in order to jump to

the next songstep earlier than after a completed pattern. The End truncate

function allows to truncate the end of an pattern in steps of quarter notes.

Navigate inside the songchain

Enter jumps to the next songstep. At the end of a song-chain, the display

reads New of XX. That means that the end of the song-chain was reached

and the song-chain editor added a new songstep at the end.

If you already have programmed some songsteps you can navigate back

and forth with the [Tempo/Shuttle]-encoder. By pushing the [Tempo/

Shuttle] encoder button the functionality of the encoder toggles between

Tempo and songstep selection.

Specifying the pattern length

Please select [Pattern] in the num button assignment section, select the

pattern, you want to change and press the Encoder button next to the

[Edit]-entry of the diplay menue. Now you see the following display

menu:

1/2:S04: Ambient PA10:Filters8 Tempo:

Len: 8/8 Bar: 4 [NAME] <Grv:Sfl>

Editing a song-chain