User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 32 of 95
EXIT....Sensitivity.Settings
........
EXIT
........R1
........R2
The receiver routing settings are used to set the audio routing from Belt Packs for the six receivers. Any
changes to these parameters under the global selection will affect all of the receivers. Alternatively,
each receiver can be set individually (R1 – R6).
Pressing SELECT on Global or one of the receivers (R1 – R6) will display a screen as follows:
...................
........BP.Button.2
BACK....BP.Button.3
The routing for each Belt Pack button is set separately. There are six outputs that the audio can be
routed to: Wireless Intercom 1, Wireless Intercom 2, Wired Intercom 1, Wired Intercom 2, Auxiliary
Out, and Stage Announce. The audio can be routed to any combination of outputs.
The following is an example of selecting R1 then BP Button 1:
........R1.B1.Wired.2...:.Dsbld
..............Aux.Out...:.Dsbld
BACK......................Dsbld
SAVE....R1.B1.Wireless.1:
..............Wireless.2:.Dsbld
B
ACK..........Wired.1...:.Enbld
SAVE....R1.B1.Wired.2...:.Dsbld
..............Aux.Out...:.Dsbld
BACK..........SA........:
........R1.B1.............Enbld
..............Wireless.2:.Dsbld
B
ACK..........Wired.1...:.Enbld
• Use the encoder to change the value.
• Options are Enbld (for enabled) and Dsbld (for disabled).
• Press SAVE to save the change or BACK to cancel.
The following table shows the settings for common routes: