User's Manual
UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 35 of 95
• To change the status, select STATUS.
• Use the encoder to change the status (Enabled or Disabled).
• Press SAVE to save the change or BACK to cancel.
........T1...Power : 100mW
.............Freq : 496.000
.....................Enabled
B
ACK....
........T1...Power : 100mW
.............Freq : 496.000
.............Status:
B
ACK....
NOTE: For operation under Part 15 of FCC Rules, the maximum transmitter power is 50mW. Higher
power requires a license under Part 74 of the FCC Rules.
LOCAL HEADSET OPTIONS
There are two local headset options: STATUS and EARPHONES.
The STATUS setting allows the local headset to be disabled, set up as listen only, or as a fully
functioning headset (talk and listen).
The EARPHONE setting controls where the receiver audio gets routed: to the left and/or right
earphones.
If SEPARATE is selected, audio from Intercom 1 will be routed to the right earphone and audio from
Intercom 2 will be routed to the left earphone.
If COMBINED is chosen, audio from both Intercoms will be routed to both earphones.
....................T/L
BACK....Earphones : Combined
BACK....
........Status : T/L
BACK............... Combined
BACK....
SAVE....Status :
BACK....Earphones : Combined
BACK....
SAVE....Status :.T/L
BACK....Earphones :
BACK....