User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 42 of 95
BASE STATION LOCAL HEADSET
MICROPHONE GAIN
• Change the local headset microphone gain by pressing the Mic Level button (below the Talk
button).
The display will change as shown below.
• Use the encoder to change the gain, and press S
AVE to save the change or BACK to ignore
it.
NOTE: The microphone gain updates in real time as it is modified.
SAVE...Mic Gain
BACK...
VOLUME
The local headset volume is control by a knob, located to the right of the TALK and MIC level buttons.
INTERCOM CH1 AND CH2 BUTTONS AND LEDS
These two buttons allow the Base Station user to transmit on Intercom Channel 1, Intercom Channel 2,
or both.
When enabled, the audio will be routed through that intercom channel (and not routed when it is
disabled).
There are two LEDs above each of these buttons:
• The one on the left is a green LED that is on when t
hat channel is enabled and off when
disabled.
• The LED on the right is a red and green LED combo. It is green when that intercom channel’s
audio is being routed and the talk button is pressed and red when this is true plus the user’s
microphone is over modulating.
TALK BUTTON
The Talk button allows the Base Station user to talk on the Intercoms. The button can be pressed and
held or “tapped” to latch on and off.