User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 53 of 95
• Press SELECT to change which digit is boxed.
• Press SAVE to save the change or BACK to ignore it.
The Belt Pack transmitter frequency range is 174.025MHz to 215.975MHz (VHF), and the step size if 5
kHz.
T1..Power..:.50mW
.............175.000
..................BACK
T1..Power..:.50mW
....Freq...:..75.000
SAVE..............BACK
D
o
w
n
D
o
w
n
The button transmit settings allow the user to configure how each transmit button works. Each button
can be disabled, setup as Push-To-Talk (PTT), or setup to be latchable. If a button is set to latch, it can
be pressed and held (PTT) or latched (tapped) on and off.
To change the button transmit settings, scroll down to box Btn<n> Tx: and press SELECT.
Use either encoder to change the value, and press SAVE to save or BACK to ignore the change.
Options for each button are Disabled, Push-To-Talk (PTT), and Latch.
T1..Btn3.Tx:.PTT
.............PTT
..................BACK
T1..Btn3.Tx:.PTT
....Btn4.Tx:
SAVE..............BACK
T1..Freq...:.175.000
.............PTT
..................BACK
D
o
w
n
D
o
w
n
T1..Freq...:.175.000
....Btn1 Tx:
SAVE..............BACK
D
o
w
n
D
o
w
n
Receiver Settings
The receiver settings allow the user to change the receiver frequencies as well as enable/disable them.
The receiver settings are located in the ADVANCED SETTINGS sub-menu.
Once selected, the screen will appear as follows: