User's Manual

UV-1G User Manual Rev. O 600MHz US – July 16
th
, 2019 66 of 95
Frequency
Belt Pack transmitters and Base Station receivers use the VHF band from 174 to 216 MHz Enter a
frequency from 174.025 and 215.975 MHz, evenly divisible by 5 kHz. Allow at least 25 kHz bandwidth
between receivers.
Right-click on a Frequency field to pop up a Frequency menu.
Enabled
A receiver may be disabled if it is not needed.
Squelch
A receiver's squelch may be adjusted between 0 (most sensitive) and 9.
Attenuation
A receiver may be attenuated 0, 5, 10, 15, or 20 dB.
Lock Status and RSSI
While the Base Station is connected, the Lock Status and RSSI are continually updated.
USING SHORTCUT KEYS
CTRL-D (COPY DOWN)
If the user changes one setting and then holds down the Ctrl key while pressing D (Ctrl-D), the setting
will be copied down to all the fields below it. This makes it easy to give all receivers to the same
settings.
CTRL-V (PASTE DOWN)
The user can copy frequencies out of an email or other document and paste them into the frequency
fields by holding down the Ctrl key while pressing V (Ctrl-V). If several frequencies are copied, each one
on a separate line, the user can paste them all it at once.
ROUTING