Owner`s manual

SAFETY INSTRUCTIONS

Warning:

Use extreme caution in the use of this de-

vice. Improper use of this device can result in injury or

death. Follow all the safeguards suggested in this own-

er’s manual in addition to normal safety precautions in

dealing with electrical circuits. Do not use this device if

you are unfamiliar with electrical circuits and testing

procedures.

Not for commercial or industrial use

This oscilloscope is designed to ensure the safest op-

eration possible. However, safe operation depends on

you, the operator. Make sure you follow these simple

safety rules:

• Read all of these instructions carefully, and save

them for your reference.

• Follow all warnings and instructions marked on

the ProbeScope.

• When making voltage measurements, never

touch the ProbeScope’s tip or a hot wire in AC

wiring circuits. If you do, you could receive an

electric shock.

• Never apply the ProbeScope to a source of power

greater than 100V DC/AC peak-to-peak. Doing so

could cause electrical shock or damage to the

ProbeScope.

Caution

: If you do not know the level of the volt-

age to measure in manual range control, always

start at the highest range: 100V DC or AC.

• Never try to measure any voltage more than 30

VAC on a DC source bias. Doing so might dam-

age your ProbeScope.

22-310.fm Page 3 Friday, August 6, 1999 12:26 PM