User's Manual

2
Changes to “Clearing All Lock Out Frequencies in a
Search Bank” on Page 50 of your Owner’s Manual
• Step 1 should read “Press
FUNC
then press
SEARCH
. “
• Step 2 should read “Select the search bank from which you
want to clear all locked-out frequencies using or .
• Please add “Press
SEARCH
to continue searching” as Step 4.
Changes to “Changing the Frequency Step” on
Page 54 of your Owner’s Manual
• Step 3 should read “Turn
SQUELCH
fully counterclockwise until
the indicator points to
MIN
” instead of “Press
FUNC
then
STEP
.”
**PAUSED**
appears on Line 3.
• Step 5 should read “Turn
SQUELCH
clockwise and leave it set to
a point just after the hissing noise” instead of “Press
FUNC
then
STEP
to return to scanning.”
Digital Weather Alert Feature
This feature supercedes “Weather Alert Feature” on Page 47 of your
Owner’s Manual.
The weather service precedes each weather alert with a digitally-
encoded SAME signal, then a 1050 Hz tone. You can set the scan-
ner so, if you are monitoring a weather channel with a digitally-
encoded SAME signal when an alert is broadcast, the scanner will
decode and display the SAME message, showing the type of alert
being broadcast (or
Unknown Message
if it does not recognize
the event code).
To set the scanner to decode and display SAME messages, press
FUNC
then
WX
while you listen to the weather channel.
DIG WX
STBY
and
Cancel: F+WX
appear.
To turn off SAME standby mode, press
FUNC
then
WX
.
DIG WX
STBY
disappears.
Notes:
• The scanner does not display the actual location referenced by
SAME messages. It uses only the message portion of the
SAME signal.
• Your scanner can also receive weather alert tones (see “Prior-
ity” on Page 51).
20-522AD.fm Page 2 Tuesday, May 9, 2000 1:13 PM