Specifications

USING LEARNING
PROGRAMMING A L
EARNING KEY
(CONTINUED)
7. On the original remote control,press and hold the key (i.e.,
feature) to be learned until [SUCCESS] appears on the
remote.The display will return to the device mode you
selected for learning (e.g., TV).
If the key was not learned, you will see an [ERROR]
message instead.
Repeat steps 5 through 7 as needed to achieve [SUCCESS].
8. To learn functions onto other keys,repeat steps 4 through 7
for each key.
9. Press EXIT to exit the programming mode.An [EXIT SETUP]
message appears as the remote returns to normal operation.
10. To test a learned feature, aim the remote at the desired
device and press its device key once (e.g.,TV, where the
learning mode was assigned). Then press the key where the
learned feature is stored.The feature should activate.If not,
try programming the key again, starting with step 1 (on
page 11).
DELETING A FUNCTION FROM A LEARNING KEY
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
2. Press ▼ three times until [IR DELETE] appears.
NOTE:Ifyou go past [IR DELETE],press ▲ one or more times to
return to it.
3. Press SELECT once to begin programming. The last-selected
device (e.g.,TV) appears.
4. Press a device key once (e.g.,TV) for the mode that contains the
learned function.
5. Press the key once where the learned function (to be delet-
ed) is stored. The display changes to [DELETED] and then
returns to last-selected mode (e.g., TV).
6. If desired, repeat steps 4 and 5 to delete other learned
functions.
7. Press EXIT to exit the programming mode.An [EXIT SETUP]
message appears as the remote returns to normal operation.
CHANGING VOLUME LOCK
In its default (unlocked) state, the remote allows each device to control its
own volume only in its own mode (e.g., TV volume in the TV mode, VCR
volume in VCR mode, etc.). However, using our Volu me Lo ck feature, you
can lock the volume controls for each device to all modes (e.g., AUDIO
volume in all modes).
Moreover, using the Volume Unlock feature (see the next page), you can
further customize the settings so that a device’s volume controls are
unlocked in one mode, but remain locked in all other modes (e.g., TV
volume in the TV mode and AUDIO volume in other modes).
PROGRAMMING VOLUME LOCK
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
8-IN-ONE
REMOTE
12 Using Learning
(x 3)
RS 8in1 IR/RF UG rev 1/2/03 10:59 AM Page 12