Specifications

USING KEYMOVER
The remote includes a Keymover feature that allows you to map
(or copy) keys from one mode (i.e., source mode) to another mode (i.e.,
destination mode).
NOTE: The following keys cannot be used as a source or destination: VCR, CBL, SAT,
TV, CD, AUX, DVD, MY SYSTEM, AUDIO,and P.
PROGRAMMING KEYMOVER
For example, if your VCR does not have volume control,try mapping the
volume and mute keys from TV mode to VCR mode as follows:
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
2. Press ▲ five times until [KEYMOVER] appears.
NOTE:Ifyou go past [KEYMOVER],press ▼ one or more times to
return to it.
3. Press SELECT once to begin programming. [FROM MODE]
appears.
4. Select a source mode (e.g., TV) and press it once.[FROM KEY]
appears.
5. Select a source key (e.g., VOL+) and press it once.[TO MODE]
appears.
6. Select a destination mode (e.g., VCR) and press it once.
[TO KEY] appears.
7. Select a destination key (e.g., VOL+) and press it once.
[SUCCESS] appears, followed by [EXIT SETUP].The remote
will automatically exit the programming mode and return to
normal operation.
8. Repeat steps 1 through 7 twice more, substituting VOL– and
MUTE as source and destination keys in steps 5 and 7.
Upon completion of the above procedure, you can now use your remote
to control the TV’s volume and mute in the VCR mode, as well as in the
TV mode.
RESTORING A S
INGLE KEYMOVED K
EY
1. Perform steps 1 through 7 of the previous section,
Programming Keymover.However, this time in step 6, make
the destination mode the same as the source mode (e.g., TV).
[CLR KMVR] appears.
2. Press SELECT once to clear the keymoved key. [DELETED]
appears, followed by [EXIT SETUP].The remote will
automatically exit the programming mode and return to
normal operation.
RESTORING ALL KEYMOVED KEYS IN A SINGLE MODE
1. Perform steps 1 through 4 of the earlier section,
Programming Keymover.However,this time in steps 3 and 4,
make the source mode and source key the same mode (e.g.,
TV). [CLR KMVR] appears.
2. Press SELECT once to clear all keymoved keys from this
mode. [DELETED] appears, followed by [EXIT SETUP].The
remote will automatically exit the programming mode and
return to normal operation.
USER’S
GUIDE
Using Keymover 15
(x 5)
RS 8in1 IR/RF UG rev 1/2/03 10:59 AM Page 15