Specifications

PROGRAMMING FAVORITE CHANNEL SCAN
In the TV, VCR, DVD, SAT,or CBL mode, the remote can store a list of up to
10 favorite channels, in any order, that will be immediately scanned when
you press FAV once (see the following section, Using Channel Scan).
NOTE: Only channels of one mode can be stored and any previously-stored channels
will be cleared.
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
2. Press ▲ three times until [FAV CHAN] appears.
NOTE:Ifyou go past [FAV CHAN],press ▼ one or more times to
return to it.
3. Press SELECT once to begin programming. The last-selected
device (e.g.,[VCR]) appears.
4. Select a mode (e.g., TV) for favorite channel scanning and
press it once. Then press SELECT once. [FAV] appears.
5. Use the keypad to enter a favorite channel number (e.g.,
031). The display shows your entry.
NOTE: If the original remote control required pressing an Enter key
to change the channel, also press ENTER after the channel number
(e.g., 0 - 3 - 1 - ENTER). However, the display will not show ENTER.
NOTE: If you made a mistake during entry, press any number key
one or more times until you see the display clear out. Then try enter-
ing the correct numbers again.
Press SELECT once. The display clears out,ready for your
next entry.
6. If desired, repeat step 5 for each favorite channel to be
stored, up to a total of 10 channels.
NOTE: Once the tenth channel is entered, the remote will
automatically exit the programming mode.
7. (Optional) To exit programming, press and hold SELECT
until [SUCCESS] appears, followed by [EXIT SETUP].The
remote will automatically exit the programming mode and
return to normal operation.
USING CHANNEL SCAN
In the VCR, CBL, SAT, TV,and DVD modes, use the SCAN (FAV) key to start a
3-second scan of all favorite channels (if programmed – see Programming
Favorite Channel Scan in the previous section) and/or all channels for the
selected mode.
1. If Favorite Channel Scan has been set up, skip to step 2.
Otherwise, on the remote,press VCR, CBL,SAT,TV,or
DVD once.
2. Press SCAN (FAV) once.
•IfFavorite Channel Scan has been set up, scanning of
favorite channels will start and, upon completion, contin-
ue to scan all channels upward for the same device.
•IfFavorite Channel Scan has not been set up, scanning
will start with the current channel,then proceed to the
next channel up, and continue until all channels of the
selected device are scanned.The red LED and IR trans-
mission icon ( ) blink each time a channel is scanned.
3. To stop scanning channels at any time, press any key once.
8-IN-ONE
REMOTE
16 Programming Favorite Channel Scan/ Using Channel Scan
(x 3)
RS 8in1 IR/RF UG rev 1/2/03 11:00 AM Page 16