Specifications

RESTORING FACTORY DEFAULT SETTINGS
The remote includes an Operation Reset program that you can use to
restore the unit to factory default settings.
IMPORTANT: Executing this program will erase all custom settings, including
Home Theater assignments, Macros, Learned Keys, Keymoved Keys, and all
device assignments.
1. On the remote, press and hold P until you see the display
change from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
2. Press ▲ once. [OPS RESET] appears.
NOTE:Ifyou go past [OPS RESET],press ▼ one or more times to
return to it.
3. Press SELECT once to begin programming. [CLR SETUP]
appears.
4. Press SELECT once to start the process.[RESET RAM] appears
as the active memory is cleared,followed by [RESET E2] as
the preprogrammed memory is restored.
An [EXIT SETUP] message appears as the remote
automatically exits the programming mode and returns to
normal operation.
USING THE IR/RF COMMAND CENTER
The remote package includes an IR/RF Command Center which receives
radio-frequency (RF) signals from the remote control,anywhere in your
home,up to 100 feet away. Once it is set up, the IR/RF Command Center
will convert the RF signals into Infrared (IR) signals to control your home
entertainment devices.
NOTE: The remote transmits both an IR and an RF signal simultaneously. It is your
option whether you want to install the IR/RF Command Center for extended remote
control range. If you choose to do so, during testing do not aim the remote at your
home entertainment devices to verify that RF transmission is working.
NOTE: The RF signal transmitted by the remote, only works with the IR/RF
Command Center.
SETTING UP THE IR/RF COMMAND CENTER
1. Find a location approximately 8 feet in front of your home
entertainment devices.It should provide (line-of-sight)
access to your equipment and a power outlet to plug in the
IR/RF Command Center.
2. Plug in the IR/RF Command Center’s power cord into an
active outlet and raise the telescoping antenna.
Tel es cop ing
Antenna
IR Lens
3. Position the IR/RF Command Center so the black IR Lens is
aimed at your home entertainment devices.
4. To test the IR/RF Command Center,take the remote into
another room in your home,up to100 feet away. Select a
device key (e.g.,TV) and press it once.Then press POWER
once.The device (e.g.,TV) should turn on.
If it does not turn on,review the steps 1 through 3 and make
any adjustments.Try step 4 again.If you continue to have a
problem,perhaps there is an IR line-of sight problem.Try
adding the enclosed IR Signal Extension Cord (see next
page).Also review the tips in Optimizing IR/RF Command
Center Reception on the next page.
8-IN-ONE
REMOTE
20 Restoring Factory Default Settings/Using The IR/RF Command Center
RS 8in1 IR/RF UG rev 1/2/03 11:00 AM Page 20