Specifications

For perfect digital sound reproduction, your compact
discs (CDs) must be clean. Your RadioShack Automatic
Compact Disc Cleaner removes fingerprints, dust, ciga-
rette smoke, and other surface contaminants that can
cause misread information and signal skips on your CDs.
FEATURES
Auto Stop
— stops automatically after a 20-second
cleaning sequence.
Precise Planetary Action
— cleans your CDs safely, us-
ing the radial movement recommended by CD manufac-
turers.
Specially Formulated Cleaning Solution
— leaves no
residue and provides approximately 200 cleanings (de-
pending on the amount of cleaning solution you spray).
Safe, Non-Abrasive Chamois Cleaning Pad
— re-
moves even the finest particles of dirt and dust without
damaging the CD’s surface.
Dust Proof Storage Case
— provides a dust-free envi-
ronment.
CONNECTING POWER
Using Batteries
Your CD Cleaner can use four AA batteries (not supplied)
for power. For the best performance, we recommend al-
kaline batteries, such as RadioShack Cat. No. 23-552.
Cautions:
• Use only fresh batteries of the required size and rec-
ommended type.
• Do not mix old and new batteries, different types of
batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
Follow these steps to install the batteries.
1. Slide off the battery compartment cover in the direc-
tion of the arrow.
2. Install the batteries according to the polarity diagram
inside the battery compartment.
Note:
For easy battery removal, place the batteries
over the white battery removal tab.
3. Replace the cover.
When the Automatic CD Cleaner’s rotation speed slows,
replace all four batteries with fresh ones.
Using AC Power
You can power the CD Cleaner from a standard AC outlet
using an optional AC adapter (Cat. No. 273-1662).
Caution:
You must use an optional AC adapter that sup-
plies 3 volts and delivers at least 300 mA. Its center tip
must be set to negative, and its plug must correctly fit the
CD Cleaner’s
3V 300mA
jack. Using an adapter that does
not meet these specifications could damage the CD
Cleaner or the adapter.
Set the adapter’s voltage switch to 3V. Connect the
adapter’s 5.5 mm outer diameter/2.1 mm inner diameter
barrel plug to the adapter and plug it into the CD Clean-
er’s
3V 300mA
jack. Then plug the other end of the adapt-
er into a standard AC outlet.
Cautions:
• Do not leave the adapter plugged into the AC outlet
or connected to the CD Cleaner when you are not
using the CD Cleaner.
• Always unplug the adapter from the AC outlet before
unplugging it from the CD Cleaner.
Cat. No.
42-228
Automatic Compact Disc Cleaner
© 1997 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.