Technical information

ManualsBrandsRadio Shack ManualsCalculatorEC-293

1

2

3

4

5

6

7

8

9

SETTING UP

Connection to the TRS-80

1.

Position the TRS-80

as

illustrated (Figure 5, rear view).

Lift

the

door

covering

the

Expansion Card-Edge, and slide it slightly

to

the right,

then

lift it up and away from

the

TRS-80 (be careful

not

to

break

the

little plastic tabs).

REMOVE DOOR OVER

TRS-BO

EXPANSION

CARD

EDGE

I

CONNECTOR

AND

CABLE

Figure

5.

Connection

to

the

TRS-aO.

2.

Attach

one end

of

the

TRS80/Expansion Interface cable

to

the

TRS-80 Card-Edge, with the cable exiting from

the

bottom

of

the

connector.

3.

Attach

the curved TRS-80

connector

hood

to

the

keyboard case;

the ribbon cable should feed

out

from

the

bottom

of

the

hood

(Figure 5).

4.

Attach

a flat

hood

onto

the

other

end

of

the cable, with the cable

exiting from

the

bottom

of

the

hood

(Figure 6).

Figure

6.

Place

hood over connector with cable exiting from

bottom

of

hood.

6