User guide

PROGRAMMING THE RC-U49C+ REMOTE CONTROL
POINT AND PRESS
®
PROGRAMMING
This method allows you to program the remote control without using codes. Instead, the remote control
automatically finds the correct command that you select in a variety of codes until you find the code that operates
your device. You then lock in the correct code as described below.
When using this method, there are several important points to remember:
• The order in which you program your electronic devices is not important.
• There may be several codes that turn your electronic devices on/off (or perform other functions). Once you
lock in a code,
be sure to check the available functions for that device (i.e. TV – Vol+/–, Mute, TV Input
(TV/VCR button), VIDEO – Play, Stop, Rew, etc., AUDIO – Volume/Mute) to see if they are operating.
• While the remote control is searching for the correct setup code(s) for your electronic devices, it is possible that
other (previously programmed) devices may turn on/off (or perform other functions). If this occurs, continue
pressing the CH+ or CH– buttons until you find the correct code for the device you are programming.
• It may take several minutes for the remote control to find the correct code that turns your device on/off
(or performs another selected function). During this time, the POWER/MODE buttons will illuminate in fast
rotation (i.e. CBL > TV > VIDEO > AUDIO > CBL, etc.).
PROGRAMMING YOUR ELECTRONIC DEVICES USING CH+ OR CH– BUTTONS
(POINT AND PRESS
®
METHOD)
1. Turn on all the electronic devices (TV, VCR, DVD, AUDIO) you want to program the remote control to operate.
2. On your remote control, press and hold SELECT, then MUTE together until the POWER/MODE buttons
illuminate in slow rotation (i.e. CBL > TV > VIDEO > AUDIO > CBL, etc.).
3. Press and hold the CH+ button until one device turns off. While you are pressing the CH+ button, the
POWER/MODE buttons will illuminate in fast rotation. As soon as one device turns off, release the CH+ button.
4. Press MUTE button.
a. If the device that turned off turns back on, press SELECT to lock in this code. The POWER/MODE buttons
will blink 3 times and go out.
or
b. If the device that turned off does not turn back on, press CH– one step at a time until that device turns
back on. Each time you press the CH– button, the POWER/MODE buttons will illuminate once in reverse
fast rotation (i.e. AUDIO > VIDEO > TV > CBL).
5. Once you have found a code that turns the device on/off, press SELECT to lock in this code. The
POWER/MODE buttons will blink 3 times and go out.
6. Repeat steps 2 to 5 above for each of the remaining electronic devices you wish to program the remote control
to operate.
REMOTE CONTROLS
24