User guide

SETUP WIZARD
HOW CAN I CHANGE HOW THE PICTURE LOOKS ON MY TV?
Press SETTINGS twice to display the General Settings menu.
Then, choose one of the following options:
Fixed — The screen resolution you selected from the Setup Wizard
can be seen in the Quick Settings menu. The screen resolution remains
the same (fixed) until you change it.
Pass-Through — This option provides a built-in convenience factor.
The set-top attempts to convert the signal of an incoming program to
the best picture format for your HDTV screen. However, if you have not
selected all the screen resolutions that are available, the screen resolution
defaults to the best selection available based on the selections you made in the HDTV Setup Wizard.
Upconvert 1 and Upconvert 2 — The operation of these two options is similar to that of the Pass-Through
option. See the Display Formats For Digital Sources table below.
Auto DVI or HDMI — If your HDTV is connected through the DVI or HDMI output, you will see this option
and not the Pass-Through option. Incoming programming is automatically formatted to the scan rate supported
by your HDTV.
DISPLAY FORMATS FOR DIGITAL SOURCES
The following table illustrates the relationship between the format option you chose, the signal the set-top receives,
and how the picture is displayed on the TV screen.
If you chose
this picture format option:
When the set-top
receives this type of signal:
The picture is displayed on
the HDTV screen in this format:
Fixed All formats 1080i, 720p, 480i, 480p
(Depending on your selections
made in the Setup Wizard and
Quick Settings menu)
Pass-Through 480i
480p
720p
1080i
480i
480p
720p
1080i
Upconvert 1 480i/480p
720p/1080i
480p
1080i
Upconvert 2 480i/480p
720p/1080i
480p
720p
69