Instruction manual

Connections (Continued)
10
Display Formats Overview
The HDTV Tuner offers various display formats and multiple video outputs. When the HDTV Tuner is connected to
A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 480p, or 480i.
1080i, 720p and 480p modes are available for component video (YPbPr) and monitor outputs.
480i mode is available for VIDEO and S-VIDEO outputs.
The HDTV Tuner has two digital audio outputs; Dolby Digital 5.1 and PCM. The HDTV Tuner sends out digital audio
signal to OPTICAL and COAXIAL audio outputs when digital broadcastings are being received by the HDTV Tuner.
Connecting to an Analog monitor
11
Connect the “Antenna” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could is too high. If so, you may need to connect the antenna
to an attenuator and screw the attenuator onto the “ANT IN” jack. (Refer to page 9.)
22
Connect the “ANT LOOP OUT” jack on the HDTV Receiver to the “ANT IN” jack on your TV using a coaxial RF
cable.
33
Connect the “AUDIO OUT” and “VIDEO OUT” jacks on the HDTV Receiver to the “A/V IN” jack on your TV
using RCA-type cables. If your VCR is equipped with an S-Video jack, use the S-VIDEO OUT jack.
ote
These connections are only available when 480i display format is selected.
Cable TV
wall jack
OR
OR
L
R
Y
Pb
Pr
COMPONENT VIDEO INPUT
AUDIO INPUT
L
VIDEO
INPUT
S-VIDEO
INPUT
ANTENNA
INPUT
Rear of TV
Rear of HDTV Receiver
Antenna