Owner`s manual

21
• If entering your security code does not disarm
the sensor alarm, try entering the default code
(1234). If that code does not disarm the alarm
either, remove the sensor alarm from the wall
and remove and reinstall the batteries. This re-
sets the security code to 1234.
USING THE CHIME ALARM
If you prefer to hear a chime instead of a siren when
the sensor alarm detects motion, follow these steps.
1. If necessary, disarm the sensor alarm (the red
indicator should not be flashing) by entering the
current security code.
2. Set the slide switch on the main unit to
CHIME
.
A doorbell-type chime immediately sounds.
3. When the sensor detects any motion, the chime
sounds again.
Note:
There is no need to arm or disarm the alarm
when using the
CHIME
setting because the chime
sounds every time the sensor detects motion. To
turn off the chime, set the slide switch to either
IN-
STANT
or
DELAY
.
49-329.fm Page 21 Wednesday, August 18, 1999 4:23 PM