Owner`s manual

when you press

ARM

DISARM

, or if the remote

control stops operating properly (the main unit can-

not receive the remote control’s signals), replace the

battery. We recommend you replace it with an alka-

line battery (available at your local RadioShack

store).

Cautions:

Use only a fresh battery of the required

size and recommended type.

Follow these steps to replace the battery.

1. Using a Phillips screwdriver, remove the screw

from the back of the remote control, then lift off

the back case.

2. Remove the old battery, then place a fresh bat-

tery inside the back cover, as indicated by the

polarity symbols (+ and –) marked inside.

3. Be sure the small loop on one end of the key-

chain fits over the post inside the back cover,

then replace the cover. Reinsert and tighten the

screw.

Note:

You do not need to reset the remote control or

main unit after replacing the remote’s battery.

49-329.fm Page 24 Wednesday, August 18, 1999 4:23 PM