2 WAY ELECTRONIC CROSSOVER WITH SUBWOOFER REMOTE CONTROL HIGH PERFORMANCE CAR AUDIO MODEL:PLXR5 www.pyleaudio.
INTRODUCTION FEATURES: 1
FUNCTIONS 1. SIGNAL INPUTS To be connected to the output of the source unit. 2. LOW PASS SUBWOOFER OUTPUT TERMINALS To be connected to the subwoofer channel amplifier left/right inputs. 3. HIGH PASS CHANNEL OUTPUT TERMINALS To be connected to the channel amplifier left/right inputs. 4. FUSE This crossover uses a 1-amp,blade-type fuses for protection from power surges or a short circuit. 5.
FUNCTIONS 9. HIGH PASS GAIN CONTROL For adjusting the channel output signal level. 10. SUBWOOFER STEREO/MONO SWITCH For selection of stereo or mono mode subwoofer output. 11. HIGH-PASS FREQUENCY SELECTOR For selection of high-pass crossover frequency between 80 Hz and 2.5KHz 12. PHASE INVERTER Position the switch to the "180" position shifts the subwoofer output signals 180 degrees out-of-phase relative to the front and rear output signals. 13.
ELECTRICAL & AUDIO CONNECTIONS 4
ELECTRICAL & AUDIO CONNECTIONS Precautions 1. To prevent short circuits, be sure to disconnect the negative battery ground lead before wiring the system up. 2. When you finish the installation, be sure to make one more check to be sure everything is done correctly. 3. Reinstate all car parts that were removed. 4. Reconnect the negative battery ground lead.
NOISE CHECK & SYSTEM ADJUSTMENT 6
TROUBLE SHOOTING GUIDE 7
INSTALLATION INSTALLATION 8
SPECIFICATIONS SPECIFICATIONS Power source: 14.4 volts DC negative ground Input current 0.5 amp max Distortion: 0.01% THD at 1 V output level Frequency response: 10Hz-30KHz ±3 dB S/N ratio (A weighted): >95dB Separation: 60 dB Crossover frequencies (continuously variable): Low-pass: 35-400 Hz High-pass: 80-2.
