- RadioShack CD Player User Manual

ManualsBrandsRadio Shack ManualsCD PlayerPRESIDIAN 42-179

Portable CD Player with Car Kit

42-179

Connecting Your CD Player

For private listening, connect the supplied earphones or

optional headphones with a 1/8-inch (3.5mm) plug into

the PHONES jack on the CD player.

To listen through your home audio system, connect an

audio cable (not included) with a 1/8 -inch (3.5-mm) plug

to the CD player’s LINE OUT jack, and connect the cable

to your audio system’s audio input jacks. Then, use the

system’s volume control to adjust the volume.

User’s Guide

Thank you for purchasing your Portable CD Player with Car Kit

from Presidian. Please read this user’s guide before installing,

setting up, or using your CD player.

In This Package

Portable CD Player Earphones

Car Kit Charging Ring

User’s Guide

Battery Notes:

• Dispose of old batteries promptly and properly.

Do not burn or bury batteries.

• Use only fresh batteries of the required size and

recommended type.

• Do not use batteries of different types,

capacities, or chemistries.

• If you do not plan to use your CD player for a

week or more, remove the batteries. Batteries

can leak chemicals that can damage electronic

parts.

• Replace or recharge batteries when the low

battery icon appears.

RF Emissions Information

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment o and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that

to which the receiver is connected.

• Consult your local RadioShack store or an experienced radio/TV

technician for help.

If you cannot eliminate the interference, the FCC requires that you stop

using your CD player. Changes or modications not expressly approved

by RadioShack may cause interference and void the user’s authority to

operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any interference received,

including interference that may cause undesired operation.

Limited 90-Day Warranty

This product is warranted by RadioShack against manufacturing defects in material

and workmanship under normal use for ninety (90) days from the date of purchase

from RadioShack company-owned stores and authorized RadioShack franchisees

and dealers. For complete warranty details and exclusions, check with your local

RadioShack store.

RadioShack Customer Relations

300 RadioShack Circle, Fort Worth, TX 76102 04/04

Powering Your CD Player

Installing Batteries

Open the CD compartment door

and the battery compartment

cover to insert two AA alkaline

batteries (not supplied) matching

the polarity

(+ and -) marked inside.

Rechargeable Batteries

Charge Ni-Cd (or Ni-Mh) rechargeable batteries (not

supplied) before using your CD player.

1. Use an AC adapter (not included) to connect your

CD player to a standard wall outlet.

2. Cover the negative end of one battery with the

supplied charging ring and place the batteries in

the compartment matching the polarity (+and-).

3. Switch CHARGE ON/OFF

on the back of the CD player to ON.

When charging is complete, slide

the switch to OFF to avoid damaging

the CD player and disconnect the AC

adapter.

Using an AC Adapter

You can power

your CD player

using a 4.5V 500

mA AC adapter (not

supplied). Insert

the barrel plug into the CD player’s DC 4.5V jack and

plug the other end of the adapter into a standard AC

outlet.

Note: You must use a Class 2 power source that

supplies 4.5V DC and delivers at least 500 mA. Its

center tip must be set to positive and its plug must t

the CD player’s DC 4.5V jack. Using an adapter that

does not meet these specications could damage the

CD player or adapter.

Using the Vehicle Adapter

Insert one end of the DC

adapter into the DC IN jack

and plug the other end into the

cigarette lighter in your vehicle.

charging ring

LINE

OUT

PHONEVOLUME

PROG.

See Programming Tracks.

BBS

Press to enhance the bass.

PUSH OPEN

Press to open the CD door.

MODE

Press repeatedly to select a playback mode:

• INTRO - The CD player will play the rst

ten seconds of each track. Press again until

INTRO disappears to cancel intro scan.

• RND – Plays tracks randomly.

• – Repeats playback of the current CD or

MP3 track.

•

ALBUM

– Repeats playback of all the MP3

tracks of current album.

•

ALL

ALL ALBUM

– Repeats all CD tracks

or all tracks of all MP3 albums.

Note: When the CD player reaches the end

of the CD or the programmed sequence, it

returns to the rst track and replays all the

tracks.

ESP/DIR

- Activates 45 seconds of

anti-shock for CDs (120

seconds for MP3 CDs). ESP

appears when active.

- MP3-CDs only: skips to

an album / rst track of an

album.

Press to turn on the player and start play. Press

again to pause playback.



Press to stop playback. Press again to turn off

the player.

 

• Press repeatedly to locate a track. When the CD is playing, press  once to return to the beginning of the current

track.

• To search for a particular section within a track, hold down  or  during play. The CD player rapidly plays the

CD either backward or forward at a high speed and low volume. When you hear the section you want, release to

resume normal play. This search stops at the end of the last track (or the beginning of track one.)

HOLD ON / OFF

Slide to ON to lock all controls (except

PUSH OPEN and volume control).

HOLD appears on the display. Slide to

OFF to unlock.

Summary of content (2 pages)

PAGE 1
Portable CD Player with Car Kit User’s Guide 42-179   • Press repeatedly to locate a track. When the CD is playing, press  once to return to the beginning of the current track. • To search for a particular section within a track, hold down  or  during play. The CD player rapidly plays the CD either backward or forward at a high speed and low volume. When you hear the section you want, release to resume normal play. This search stops at the end of the last track (or the beginning of track one.
PAGE 2
Using Your CD Player To Maintain Good Performance • Do not store CDs in high temperature or high humidity areas. They might warp. Loading a CD Do not use the unit in places that are extremely hot, cold, dusty, or humid, such as: • Keep CDs dry. A water drop can act as a lens and affect the laser beam’s focus. 1. Power on your CD player and press PUSH OPEN to open the CD door. • In a high humidity area, such as a bathroom near a heater. 2.